Solenoid for Supra

Thermister Temp Sensor RAS/RAT/SAT

High Pressure Cutout Switch HP1
Carrier Truck Units

High Pressure Cutout Switch HP2
Carrie Truck Units

COIL 12V SOLENOID

THERMISTOR SENSOR
use part# TB-22-02973-10-AM in place of.

THERMISTOR SENSOR

Exhaust Flex Pipe - Manifold to Muffler
Fits: Extra, Genesis, Ultra XL

Exhaust Flex Pipe - Manifold to Muffler
Fits: X2 2100 2500 - X4 7300 7500 - Ultra XTC - Extra XT

Exhaust Flex Pipe (Manifold to Muffler) with Hardware

CLAMP EXHAUST PIPE

MUFFLER SUPRA® 622/644/650/722/744/750/844/850

MUFFLER KIT FOR SUPRA® 622/644/650/722/744/750/844/850

Fuel Filter for Davco Fuel Filter

70 Amp Alternator CCW WITH PULLEY
X2 - 2100/2500 & X4 - 7300/7500 Units

Oil Filter Extended Life
Fits Models: Supra 560/660/760/860/960

EXHAUST PIPE

Muffler for Supra® 450 550

MUFFLER RECTANGULAR FOR SUPRA® 922/944/950/960
(LOW NOISE)

OEM MUFFLER KIT RECTANGULAR SUPRA® 922/944/950/960

Fuse Kit
Contains:

Insert and Sleeve for 3/8" Hose

Fuel Line Hose for 486 engine

End Cap for Fuel Line

Clamp for Fuel Line

1/4 SAE x 1/8 MPT Shrader Valve

Clip for Rod Linkage (Left side)

Clip for Throttle Linkage (Right Side)

Compression Fitting Kit for 1/4 inch fuel line
with 1/8-NPT male fitting.

Locking Fuel Cap

Cover for Thermostat - SB, Super II & Precedent® Units with Yanmar Engine

SPEED CONTROL ROD

VALVE EASY OIL DRAIN

Fuel Filter for SB130, 230, 330

Oil Filter for Precedent®

Oil Filter, Severe Duty Precedent®

Muffler Tripac®

MUFFLER KIT FOR ALL "T" SERIES TRUCK UNITS
Includes: Muffler, Clamp, End Pipe & Gasket

Vibration Mount (Front) Precedent® Units

Vibration Mount (Rear) Precedent® Unit

Fitting for 3/8" Fuel Line - Precedent® Units

FUEL FILTER STRAINER FOR TRIPAC® EVOLUTION

UPPER HOSE TRIPAC® EVOLUTION (units after July 2013)

Water Pump for Yanmar 486 Engine (New Version)

Water Pump for Precedent® Unit w/488 Engine
***NOTE: This new style water pump may not fit without modifications
to the adapter plate that is located between the engine block and water pump.***


Click here for Instructions

Gasket, Valve Cover 486V engine

INJECTOR ASSEMBLY 270 370 YANMAR

SEAL SHAFT X430P COMPRESSOR - Precedent® & SB Units with X430P compressor w/internal oil filter

Gasket for Blower D2 Heater - Tripac

Gasket for Blower D4 Heater - Tripac

Gasket for Seal Plate on Compressor Model:  X430P

Inline 50 amp Fuse Kit for Tripac®
*Note - This kit replaces the Maxi Fuse holder*

Light Bar - Status Display for SB units

Light Bar - Status Display for Precedent® Units

Coil for Pilot Solenoid 12V

Coolant Level Sensor

Blower Assembly for D2 Heater - Tripac

Strainer Glow Pin Tripac®

Fuel Pump for D2/D4 Heater - Tripac

Blower Assembly for D4 Heater - Tripac

Radiator Temp Switch TriPac®
*Turns on Electric Radiator Fan when Temperature reaches 115 degrees F.

Starter for Precedent® Multi Temp Unit with Peugeot Engine

Low Pressure Pressure Transducer
SBxxx Units w/ETV

60 amp Inline Fuse Kit for Truck Units
*Note - This kit replaces the Maxi fuse*

High Pressure Transducer (Discharge Side)
Precedent® and SBxxx Units

PUMP FUEL PRECEDENT

Facet SS Fuel Pump Precedent® Unit

Glow Pin Kit for TriPac® Espar Heater model D2 or D4

Shunt Resistor for Relay Board

120amp Alternator Czech Style

ALTERNATOR 65AMP NO FAN

Can Use Part# TB-37-45-2256-AM

120amp Alternator for Tripac
(Dual Output Regulator - for Tripac® ONLY)
**NOTE** - The "FLD" Field Terminal must be connected to the Load Control Harness. If you DON'T have a Load Control Harness the "FLD" Field Terminal must be connected to a GROUND or the Alternator WILL NOT function.

FITTING ELBOW 1/4 BARB